Servicing The Spark Plug - Toro 30320 Operator's Manual

m–6574
Figure 29
1. Oil drain valve
9. Slowly pour approximately 80% of the specified oil,
page 27, into the filler tube (Fig. 28).
10. Check the oil level; refer to Checking Oil Level,
page 27.
11. If needed, slowly add additional oil to bring to the full
mark on dipstick.
Changing the Oil Filter
Service Interval and Specification
Replace the oil filter every 200 hours or every other oil
change.
Note: Change oil filter more frequently when operating
conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Changing/Draining Oil, page NO TAG.
2. Remove the old filter (Fig. 30).
3. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Fig. 30).
1
Figure 30
1. Oil filter
2
1
2. Drain hose
2
2. Adapter
28
4. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 3/4 turn (Fig. 30).
5. Fill the crankcase with the proper type of new oil;
refer to Engine Oil Service, page 27.

Servicing the Spark Plug

Service Interval and Specification
Check the spark plug(s) after every 100 operating hours.
Make sure the air gap between the center and side
electrodes is correct before installing the spark plug. Use a
spark plug wrench for removing and installing the spark
plug(s) and a gapping tool/feeler gauge to check and
adjust the air gap. Install a new spark plug(s) if necessary.
Type: Champion RCJ8Y or NGK BPR4ES
Air Gap: 0.030 in. (.75 mm)
Removing the Spark Plug
1. Disengage the power take off (PTO), chock or block
tires, and turn the ignition key to off. Remove the key.
2. Pull the wire(s) off the spark plug(s) (Fig. 31). Now
clean around the spark plug(s) to prevent dirt from
falling into the engine and potentially causing damage.
3. Remove the spark plug(s).
1
Figure 31
1. Spark plug wire installed
Checking the Spark Plug
1. Remove spark plug.
2. Look at the center of the spark plug(s) (Fig. 32). If you
see light brown or gray on the insulator, the engine is
operating properly. A black coating on the insulator
usually means the air cleaner is dirty.
(s)
2
2. Spark plug