5. Check the parking brake adjustment (Fig. 10). Refer to
Checking the Brakes, page 32.
Note: Make sure brake rod is installed in front (F)
mounting hole in idler bracket.
2
3
Figure 10
1. Upper control bar
2. Parking brake lever
Parts needed for this step:
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 11).
1
m–5233
3. Fixed bar
17
3
2
1
Figure 11
1. Hairpin cotter
2. Unused spacers
Parts needed for this step:
1 Rear weight
2 Capscrews
2 Washers
2 Nuts
Installing the Rear Weight
1. Remove lag screws securing weight to shipping crate.
Remove weight and discard screws.
2. Secure weight to rear of frame with 2 capscrews,
washers and nuts (Fig. 26).
Note: The weight mounted in the rear position is
recommended, except when a Tru–Trak Sulky is
installed.
m-6505
3. Height–of–cut post