3. Adjust control rod length by threading rod in or out of
rod fitting until there is a 3/16 to 1/4 in. (5 mm to
6 mm) clearance between the control rod and bottom of
neutral/brake lock (Fig. 8).
4. Install control rod to drive lever and neutral/brake lock.
Secure with clevis pin and hairpin cotter.
5. Check operation. If adjustment is required, remove
hairpin cotter and clevis pin securing rod to drive
levers.
6. Adjust control rod length by repeating steps 3 and 4
(Fig. 8).
3
5
6
4
Figure 8
1. Handle
2. Neutral/Parking brake
lock
3. 3/16 in. to 1/4 in. (5 mm to
6 mm) clearance
Parking Brake Adjustment
1. Refer to Brake Service on page 30 for checking brakes
and adjusting them.
Install Hairpin Cotter Pins
Spare height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On opposite side of muffler, install extra hairpin cotter
pins into front and rear height–of–cut pins (Fig. 9).
2
1
m–5387
4. Drive lever
5. Forward speed
6. Control Rod
16
Figure 9
1. Hairpin cotter
2. Extra spacers
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Think Safety First
Carefully read all the safety instructions and decals in the
safety section. Knowing this information could help you,
your family, pets or bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet and
head is recommended.
Caution
This machine produces sound levels in excess of
85dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.
1
Figure 10
1. Caution
m–5314
3. Height–of–cut post
2
2. Wear hearing protection