BT Studio 3500 User Manual page 8

8474 Studio 3500 UG Iss2 [2]
8 Getting started
Battery performance
To keep the batteries in the best
condition, leave the handset off the
base for a few hours at a time.
Running the batteries right down at
least once a week will help them last
as long as possible.
After charging your handset for the
first time, subsequent charging time for
the batteries is approximately 6–8
hours.
The charge capacity of rechargeable
batteries will reduce with time as they
wear out, thus reducing the
talk/standby time. Eventually they
will need replacing.
New batteries are available from the
BT Studio Helpline on
0870 605 8047 or email
bt.helpdesk@suncorptech.com.
If you experience any problems, please call the Helpline on 0870 605 8047 or email bt.helpdesk@suncorptech.com
25/10/07 16:37
BT Studio 3500 – Issue 1 – Edition 2.1 –02.04.07 – 7999
BT Studio 3500 multipack users only:
Place each BT Studio 3500 charger within reach of a mains
power wall socket.
Connect the charger(s) and charge the handset(s)
i. Plug the mains power adaptor into the power socket on the
underside of the charger and plug the other end to the mains
power wall socket.
ii. Insert the 2 x AAA rechargeable batteries supplied, taking
note of the polarity markings inside the battery
compartment, then slide the battery compartment shut.
iii. Place the handset on the charger. You should let the batteries
charge continuously for at least 24 hours.
The display will show the time and the handset number e.g.
2 , to show it is registered to the base.
Your phone is now set up to make and receive calls. Please
note that the answering machine is already switched on and is
ready to answer incoming calls.
To switch the answering machine off press
The machine announces "Answer Off". See page 27 for more
information about your answering machine.
Page 8
on the base.