Saving Your Performance Settings (Registration); Recalling A Registration; Saving Current Settings Into A Registration - Roland GP607 Owner's Manual

Advanced Operation
˙

Saving Your Performance Settings (Registration)

Tone settings and settings such as Dual Play or Split Play can be
saved and recalled easily.
Such settings are called a "registration. "
You can save a total of 25 registrations, five each in buttons [1]-[5].
These 25 registrations are collectively called a "registration set. "
1-5 2-5
1-1 2-1 3-1
25 registrations
Registration set
Settings that are saved in a registration
Setting
Ambience
Rotary Speed
Key Touch
Transpose
The selected tone (including Split or Dual tones)
Split on/off
Split point
Left Shift
Dual on/off
Tone 2 Shift
Balance (Split, Dual)
Twin Piano on/off
Twin Piano Mode
Damper Pedal Part
Center Pedal
Left Pedal
MIDI Transmit Ch
16
3-5 4-5 5-5
4-1 5-1

Recalling a Registration

1.
Press the [Registration] button.
2.
Press a number button ([1] to [5]) to choose the location
where the desired registration is saved.
3.
Press the [-] [+] buttons to select the registration variation.
The settings change accordingly.
You can press the [J] button to edit the selected registration.
MEMO
5 You can also use a pedal to recall registrations (p. 21).
5 If you press the [Registration] button to exit the Registration
screen, you will return to the state prior to recalling the
registration.

Saving Current Settings into a Registration

NOTE
Page
When you save a registration into a location, it will overwrite any
p. 8
registration already stored at that location.
p. 8
1.
p. 8
While holding down the [Registration] button, press a
p. 8
button from [1] to [5] to select a registration and then press
p. 8
the [-] [+] buttons to select a registration variation.
p. 9
p. 9 2.
Rename the registration.
p. 9
p. 9
[K] [J] buttons
p. 9
p. 9 [-] [+] buttons
p. 9
If you decide to cancel, press the [u] (Exit) button.
p. 9
p. 21
3.
Press the [s] (Enter) button.
p. 21
p. 21 The registration is saved.
p. 22
NOTE
Never turn off the power while the screen indicates "Executing... "
Select the position at which you want to change
the character.
Change the character.