Table of Contents
Advertisement
3.7
Warranty
Warranty claims shall be voided in case
Our conditions in the operation manual are ignored
The appliance is used outside the described uses
The appliance is modified or opened
Mechanical damage and damage caused by media, liquids,
Natural wear and tear
The appliance is improperly set up or incorrectly electrically connected
The measuring system is overloaded
3.8
Safe working
Do not stand under swinging loads, see chap. 6.1.
Position the crane in a way that the load is lifted vertically.
When working with the crane and suspended balance wear personal safety
equipment (helmet, safety shoes etc.).
3.9
Monitoring of Test Resources
In the framework of quality assurance the measuring-related properties of the
balance and, if applicable, the testing weight, must be checked regularly. The
responsible user must define a suitable interval as well as type and scope of this test.
Information is available on KERN's home page (www.kern-sohn.com) with regard to
the monitoring of balance test substances and the test weights required for this. In
KERN's accredited DKD calibration laboratory test weights and balances may be
calibrated (return to the national standard) fast and at moderate cost.
3.10 Testing upon acceptance
Inspect packaging immediately upon receipt and inspect device when unpacking, see
chap. 5.1. in the event of any evident damage.
3.11 Initial Commissioning
In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1).
During this warming up time the balance must be connected to the power supply
(mains, accumulator or battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.
For checking original dimensions, s. chap. 5.3
3.12 Shutdown and storage
Switch off suspended balance and remove batteries
Do not store suspended balance outdoors.
12
HDB-BA-e-1730
Advertisement
Table of Contents
