Advertisement
General Safety Instructions
Read this manual thoroughly before first use and keep it in a safe place for
future reference, along with the completed warranty card, purchase receipt
and carton. The safety precautions enclosed herein reduce the risk of fire,
electric shock and injury when correctly adhered to.
Follow all instructions and take notice of all warnings to reduce the risk
of fire or electric shock.
Electrical safety and cord handling
• Before installing this equipment, make sure your outlet voltage corresponds
to the voltage stated on the appliance rating label.
• To prevent contact with high voltage components inside, do not attempt to
open the equipment.
• When connecting the equipment, align the plug properly and insert it fully to
prevent electric shock.
• Only use this equipment with the cord and plug supplied, and do not overload
the power outlet.
• If the power cord is damaged, do not use the equipment. The cord must be
replaced by the manufacturer or similarly qualified personnel in order to avoid
a hazard. Contact the after sales support line for advice.
• CAUTION: To reduce the risk of fire or electric shock, do not expose this
equipment, the power supply cord and plug to rain or moisture; do not use it
anywhere near water or where water splashes or drips; do not touch the
power plug with wet hands. In the event that water or other liquids enter the
device, unplug the unit immediately and clean and dry it as best as possible.
Then have it checked for damage by a qualified technician. Contact the after
sales support line for advice.
• Do not repair the unit yourself. Only have it serviced by qualified personnel.
Contact the after sales support line for advice.
• Unplug the unit from the power outlet after use to avoid possible damage
during electrical storms, or when the equipment will be unattended or unused
for a long period of time.
• Do not let the cord hang over the edge of a table or counter, or touch any hot
surface. Do not allow anything to rest on or roll over the power cord, and run
any cords so that no one steps on or trips over them.
• Do not run the cord near heat-producing appliances such as radiators, stoves
or irons. The excessive heat could melt the insulation and expose live wires.
• Always grasp the plug, not the cord, when disconnecting the unit. Pulling the
cord can damage the internal wires and may cause a fire.
- 2 -
1
Advertisement
