General Safety Instructions; Electrical Safety And Cord Handling - boytone BT-17DJM Instruction Manual

General Safety Instructions

Read this manual thoroughly before first use and keep it in a safe place for future reference,
along with the completed warranty card, purchase receipt and carton. The safety precautions
enclosed herein reduce the risk of fire, electric shock and injury when correctly adhered to.
Follow all instructions and take notice of all warnings to reduce the risk of fire or electric
shock.

Electrical safety and cord handling

• Before installing this equipment, make sure your outlet voltage corresponds to the voltage
stated on the appliance rating label.
• To prevent contact with high voltage components inside, do not attempt to open the
equipment.
• When connecting the equipment, align the plug properly and insert it fully to prevent electric
shock.
• Only use this equipment with the cord and plug supplied, and do not overload the power
outlet.
• If the power cord is damaged, do not use the equipment. The cord must be replaced by the
manufacturer or similarly qualified personnel in order to avoid a hazard. Contact the after sales
support line for advice.
• CAUTION: To reduce the risk of fire or electric shock, do not expose this equipment, the power
supply cord and plug to rain or moisture; do not use it anywhere near water or where water
splashes or drips; do not touch the power plug with wet hands. In the event that water or other
liquids enter the device, unplug the unit immediately and clean and dry it as best as possible.
Then have it checked for damage by a qualified technician. Contact the after sales support line
for advice.
• Do not repair the unit yourself. Only have it serviced by qualified personnel. Contact the after
sales support line for advice.
• Unplug the unit from the power outlet after use to avoid possible damage during electrical
storms, or when the equipment will be unattended or unused for a long period of time.
• Do not let the cord hang over the edge of a table or counter, or touch any hot surface. Do not
allow anything to rest on or roll over the power cord, and run any cords so that no one steps on
or trips over them.
• Do not run the cord near heat-producing appliances such as radiators, stoves or irons. The
excessive heat could melt the insulation and expose live wires.
• Always grasp the plug, not the cord, when disconnecting the unit. Pulling the cord can damage
the internal wires and may cause a fire.
Installation
• When installing the unit, make sure to place it: