Table of Contents
Advertisement
Discovery 266 • Owner's Manual Supplement
Preparing the Water Heater for Use After Winterizing
WATER HEATER DAMAGE HAZARD!
• Fill the water heater tank BEFORE turning On the water heater breaker on the 110-volt AC
master panel.
• NEVER turn On the water heater breaker on the 110-volt AC master panel while the water
heater tank is empty.
• To test if the tank is full, turn On a hot water faucet. If water flows from the tap, the water
heater tank is full.
• Even brief water heater operation with a dry tank WILL damage the heating elements.
• Warranty replacements will NOT be made on elements damaged in this manner.
When you are ready to resume use of your boat after it has been in storage, prepare the water heater for use
as follows:
1. Close the drain valve (C).
2. Close the pressure relief
valve (B).
3. Connect the hose (A)
to the pressure relief
valve (B).
4. Fill the water heater tank
with freshwater.
5. Remove the 'winterized'
tag on the water heater
breaker on the 110-volt
AC master panel after
the water heater tank is
completely filled with
freshwater.
6. Turn On the water heater
breaker.
!
C A U T I O N
NOTE:
TYPICAL WATER
HEATER SHOWN.
LOCATIONS OF
FITTINGS MAY
VARY BY BRAND
AND MODEL.
C
110-VOLT AC MASTER PANEL
Chapter 6: Plumbing
WATER HEATER
BREAKER TAG
B
A
43
Advertisement
Table of Contents
