Loading Firmware; Tcp/Iq Utility - Crown I-Tech I-T6000 Application Manual

Section 3: I-Tech Settings
Figure 3.8
Front Panel
Worksurface Controls
Figure 3.9
Example Preset Menu
Screen
Figure 3.10
Verify Recall or Store
Preset Prompt
Note: If the status of any setting such as attenuation is changed from what is stored in the preset the text
"Changed" will appear in the upper left corner of the speaker preset display. The text will be removed once
the setting is returned to it's original setting, or the preset is "resaved" or recalled.
Note: Exercise caution when recalling presets. Gain and fi ltering may vary signifi cantly between presets.
Test at a very low level before turning the sytem up.
To recall a preset from IQwic software:
• Open the Component Control Panel of the amplifi er in IQwic.
• Expand the Control Panel to gain access to the Presets tab, as shown in Figure 3.7.
• Click on any of the buttons for the preset. A prompt will appear allowing you to
either recall a preset or store a preset to that preset number, as shown in Figure 3.9.
Choose "Recall this preset"
See the Help fi les in IQwic for more about storing and recalling presets.

3.5 Loading Firmware

Your I-Tech amplifi er can be easily updated with the lastest fi rmware as new versions
are released by Crown. Use the TCP/IQ Utility program to load fi rmware into your
amplifi er.

3.5.1 TCP/IQ Utility

TCP/IQ Utility allows you to update the fi rmware of your TCP/IQ component as they
are made available. The program also serves as a setup and troubleshooting tool for
TCP/IQ IQ Networks. Open the TCP/IQ Utility program by choosing it under
Start > Programs > IQ Systems > IQwic > TCP/IQ Utility.
Application Guide
13