Table of Contents
Advertisement
Getting started
Battery installation and charging
Install the battery, as shown below.
screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the telephone base or charger
when not in use. The battery is fully charged after ten hours of continuous
charging.
See the table on page 124 for battery operating times.
If the screen shows Place in charger and
handset without interruption
enough charge to use the telephone for a short time.
summarizes the battery charge indicators and actions to take.
Battery indicators
The screen is blank, or
shows Place in charger
and
(flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
1. Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label
THIS SIDE UP facing up, as indicated.
Once you have installed the battery, the
for at least 30 minutes to give the handset
Battery status
Battery has no or very
little charge. The handset
cannot be used.
Battery has enough charge
to be used for a short time.
Battery is charged.
9
flashes, you need to charge the
The following table
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
Advertisement
Table of Contents
