Adjusting The Pc Image Automatically; Adjusting The Pc Image Manually - Sharp Aquos LC-46LE700X Operation Manual

Connecting a PC

Adjusting the PC image automatically

This function enables the screen to be automatically
adjusted to its best possible condition when the
analogue terminals of the TV and PC are connected
with a commercially available DVI/D-sub conversion
cable, etc.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "Auto sync.", and then
3
press ENTER.
Press c / d to select "Yes", and then press
4
ENTER.
• Auto sync. starts and "Adjusting the image"
displays.
[ Setup ... Auto sync. ]
MENU
Auto adjustment of image display parameters
Yes
Press MENU to exit.
5
NOTE
• When Auto sync. is successful, "Auto sync completed
successfully" displays. If not, Auto sync. failed.
• Auto sync. may fail even if "Auto sync completed
successfully" displays.
• Auto sync. may fail if the computer image has low
resolution, has unclear (black) edges, or is moved while
executing Auto sync.
• Be sure to connect the PC to the TV and switch it on
before starting Auto sync.
• Auto sync. can be executed only when inputting analogue
signals.
No
Auto sync.
30%
Adjusting the image.

Adjusting the PC image manually

Ordinarily you can easily adjust the picture as
necessary to change image position using Auto sync.
In some cases, however, manual adjustment is needed
to optimise the image.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "Fine sync.", and then
3
press ENTER.
Press a / b to select the specifi c adjustment
4
item.
Image position adjustment, etc.
H-pos. [ 90] –
V-pos. [ 39]
–
Clock [ 90]
–
Phase [ 20]
–
Reset
Selected item
H-pos. Centres the image by moving it to the left
or right.
V-pos. Centres the image by moving it up or
down.
Adjusts when the image fl ickers with
Clock
vertical stripes.
Phase Adjusts when characters have low
contrast or when the image fl ickers.
Press c / d to adjust the item to your desired
5
position.
Press MENU to exit.
6
NOTE
• For resetting all adjustment items to the factory preset
values, press a / b to select "Reset", and then press
ENTER.
• "Clock" and "Phase" in the "Fine sync." menu can be
adjusted only when inputting analogue signals.
H-pos. adjustment
+
V-pos. adjustment
+
+ Clock freq. adjustment
Clock phase adjustment
+
Return to factory pre-settings
Description
57