Checking Signal Strength And Channel Strength - Sharp Aquos LC-46LE700X Operation Manual

Preparation
Initial auto installation (continued)
The TV searches for, sorts and stores all
5
the receivable TV stations according to their
settings and the connected antenna.
• To abort the initial auto installation in progress,
press RETURN.
NOTE
• HOME mode: Settings are optimised for normal home
viewing and energy effi ciency.
• STORE mode: Settings are designed for maximum impact
in retail store displays.
• To change the STORE mode to HOME mode, please refer
to page 65 to reset the unit.
• If you turn off the power on the TV after performing step
4, the initial auto installation wizard does not appear. The
auto installation function allows you to execute the auto
installation again from the Setup menu. (Page 20)
• The initial auto installation wizard will go off if you leave
the TV unattended for 30 minutes before searching for
channels in step 5.
12
Checking signal strength and
channel strength
If you install a DVB-T antenna for the fi rst time or
relocate it, you should adjust the alignment of the
antenna to receive a good reception while checking
the antenna setup screen.
Press MENU and the MENU screen displays.
1
Press c / d to select "Setup".
2
Press a / b to select "Antenna setup-DIGITAL"
3
and then press ENTER.
H Checking signal strength
Press a / b to select "Signal strength".
Supply voltage
Signal strength
Channel strength
H Checking channel strength
Press a / b to select "Channel strength", and
then press ENTER.
Supply voltage
Signal strength
Channel strength
Position and align the antenna so that the
4
maximum possible values for "Signal strength"
and "Quality" are obtained.
NOTE
• The values of "Signal strength" and "Quality" indicate when
to check the appropriate alignment of the antenna.
CH No. 21
Signal strength
Current 0 Max. 0
Quality
Current 0 Max. 0
2 6 5 . 2
MHz
CH No. 21
Signal strength
Current 0 Max. 0
Quality
Current 0 Max. 0