Sleep And Auto Sleep - Kyocera TASKalfa 266ci Operation Manual

Preparation before Use > Energy Saver function

Sleep and Auto Sleep

To enter Sleep, press the Energy Saver key. Touch panel and all indicators on the operation
panel will go out to save a maximum amount of power except the Energy Saver key, and Main
Power indicators. This status is referred to as Sleep.
If print data is received during Sleep, the touch panel lights up and printing starts.
Received data is printed out while the operation panel remains unlit.
To resume, press the Energy Saver key. The machine will be ready to use within 20 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to
respond more slowly.
NOTE
When a preset time of Low Power Timer and Sleep Timer is same, Sleep Mode overrides
Low Power Mode.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time. The
default preset time is 15 minutes.
For more information about configuring settings, refer to Sleep Timer on page 9-27.
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. In addition, it takes longer for the
machine to wake and return to normal operation.
For more information on Sleep Rules settings, refer to Sleep Rules (models for Europe) on page 9-
27.
Sleep Level (Energy Saver) (models except for Europe)
This mode reduces power consumption even more than normal Sleep mode, and allows Sleep
Mode to be set separately for each function. The time required for the machine to wake up
from power save mode and resume normal operation will be longer than for normal Sleep
Mode.
NOTE
If the optional network interface kit is installed, Energy Saver cannot be specified.
For more information on Sleep Level (Energy Saver) Mode settings, refer to Quick Setup Wizard on
page 3-29.
2-28