Error Messages - Brother 888-H72 Operating Manual

Troubleshooting

Error messages

If the "Start/Stop" button is pressed before the machine is correctly set up or if an operation is performed incorrectly, an error
message appears in the LCD. Follow the instructions that appear. The message will disappear if
message is displayed.
Error Messages
1
2
3
4
5
6
7
8
A-18
This message is displayed when the sewing speed controller is set to control the
zigzag stitch width, and the "Start/Stop" button is pressed. Set
to "OFF" (refer to page B-12), or use the foot controller to operate the machine.
This message is displayed when
that cannot be sewn with the twin needle is selected.
This message is displayed when the "Start/Stop" button was pressed while the foot
controller was connected.
This message is displayed when the buttonhole lever is down, a stitch other than a
buttonhole is selected, and a button, such as the "Start/Stop" button, is pressed.
This message is displayed when the buttonhole lever is up, a buttonhole stitch is
selected, and a button, such as the "Start/Stop" button, is pressed.
This message is displayed when a button, such as the "Start/Stop" button, was
pressed while the presser foot was raised.
This message is displayed when you tried to combine more than 70 decorative
stitches.
This message is displayed when the stitch mode was changed.
or is pressed while the
Cause/Solution
(Twin needle) is set to "ON", and a stitch pattern
(Width control)