Table of Contents
Advertisement
Appliqué, Patchwork and Quilt Stitching
e
Hold the quilting foot in place with your right hand,
and tighten the presser foot holder screw using the
screwdriver with your left hand.
1 Presser foot holder screw
CAUTION
• Be sure to securely tighten the screws with the
included screwdriver. Otherwise, the needle
may touch the quilting foot, causing it to bend
or break.
f
Use both hands to stretch the fabric taut, and then
move the fabric at a consistent pace in order to sew
uniform stitches roughly 2.0 mm - 2.5 mm (approx.
1/16 inch - 3/32 inch) in length.
1 Stitch
g
After sewing is finished, slide the feed dog position
switch lever to
(to the right as seen from the rear
of the machine) and turn the handwheel to raise the
feed dogs.
Memo
• Do not be discouraged with your initial results.
The technique requires practice.
S-32
Satin stitching using the sewing speed
controller
A decorative stitch can be sewn by changing the stitch width
of a satin stitch. If the machine is set so that the stitch width
can be adjusted using the sewing speed controller, the stitch
width can quickly and easily be adjusted. In this case, the
sewing speed is adjusted with the foot controller.
a
Connect the foot controller.
Attach zigzag foot "J".
b
c
Press
to display the settings screen, and set
"Width Control" to "ON".
The settings screens differ depending on the models.
→ The machine is now set so that the stitch width can
be controlled with the sewing speed controller.
Press
.
d
e
Select stitch
.
J
Advertisement
Chapters
Table of Contents
Troubleshooting
