Brother DCP-J925DW Quick Setup Manual page 5

d
Unpack the ink cartridge.
Turn the green release lever on the orange
protective packing a clockwise until it clicks to
release the vacuum seal. Then remove the
orange protective packing a as shown.
IMPORTANT
DO NOT shake the ink cartridges. If ink stains
your skin or clothing, wash with soap or
detergent at once.
e
1
f
1 1
Take care to match the colour of the lever a
with the cartridge colour b, as shown in the
diagram below.
Install each ink cartridge in the direction of the
arrow on the label.
Gently push the back of the ink cartridge
marked "PUSH" until it clicks. After all the ink
cartridges are installed close the ink cartridge
cover.
Note
The machine will prepare the ink tube system for
printing. This process will take approximately four
minutes. Do not turn off the machine.
1
2
5