UPX-2 1GB Memory & OS Upgrade
Installation
NOTE: Prior to beginning the installation procedure, it is recommended
that you note all of the UPX-2's configuration settings. All settings need
to be reentered after completing the upgrade procedure.
Required Equipment
•
•
•
Refer to the following diagram when performing this procedure.
Rear Panel of UPX-2
MOUSE PORTS
1. Use the power switch on the rear of the unit to turn off power.
2. Use a flat-head screwdriver to remove the flash memory access
3. Eject the installed compact flash card by pressing the eject button,
4. Remove the old compact flash card from the card slot and replace
5. Replace and secure the flash memory access cover.
6. Connect the USB or PS/2 mouse to the UPX-2.
7. Use the power switch to turn on the UPX-2. The license agreement
2 • 1GB Memory & OS Upgrade: UPX-OS1GB(-MSO)
Flat-head screwdriver
Compact flash card
®
USB or PS/2
mouse
FLASH MEMORY ACCESS
cover and reveal the flash memory card slot.
located on the right-side of the slot.
with the new compact flash card. The new card should be installed
with the Crestron label facing up.
NOTE: The old card cannot be reused for data storage.
will be displayed after approximately 30 minutes.
Crestron UPX-OS1GB(-MSO)
POWER SWITCH
Installation Guide - DOC. 6443