Crestron TPS-4500IMC User Manual page 6

Interface Module
Physical Views of the TPS-4500IMC
0.235 in
(0.597 cm)
0.750 in
(1.905 cm)
0.750 in
(1.905 cm)
2 • Interface Module: TPS-4500IMC
CAUTION: Verify that jumpers and six-pin video connector are installed
at all times, except for differential input (balanced) video signal.
Refer to "Hardware Hookup" beginning on page 5 for details.
CRESTRON
TPS -4500 IMC
NET
24 Y Z G
• NTSC/PAL VIDEO – These three ports are made active with
the purchase and installation of the TPS-VID, composite and
S-video input for TV video card. Consult the latest revision of
the TPS-VID Operations & Installation Guide (Doc. 5869) for
details. Use either the two BNC connectors or the six-pin
connector when connecting to a video source.
CAUTION: Except for differential input (balanced) video signal,
the six-pin video connector with jumpers should be installed at all
times. Refer to "Hardware Hookup" beginning on page 5 for
details.
• NET – This four-pin connector is used to connect to other four-
wire devices in the Cresnet system. If making network
connections to Cresnet peripherals, refer to "Network Wiring"
on page 4 for details.
Crestron TPS-4500IMC
NTSC/PAL VIDEO
COMP
COMP C
+ _
Y C S +
4.820 in
(12.243 cm)
5.325 in
(13.526 cm)
Operations Guide - DOC. 5890
1.240 in
(3.150 cm)
2.000 in
(5.080 cm)
Y
_
S
0.250 in
(0.635 cm)