High Tech Pet humane contain HC-8000 Installation And Operation Manual page 20

STEP 2: Assemble the Required Tools
Here is the list of tools you will need.
1.
Straight edge spade or power edger
2.
Wire cutter/stripper
3. Power drill with 1/8" drill bit
4.
Phillips screwdriver or Phillips driver bit for your drill
STEP 3: Set Up the Base Station Transmitter
Mounting:
A. Separate Mounting Base From Electronics Console.
C: Install Optional Rechargeable Battery if Desired.
Indoor mounting of the TX-1 Base Station Transmitter is preferred.
However, if your layout prohibits indoor mounting, it is acceptable to
mount the TX-1 outdoors. Although the casing is water-sealed, you
should still choose a location that is not directly exposed to rain, wind
and other adverse weather.
______________________________________________________________________________________
20
D. Reassemble Mounting Base and Electronics Console
by Pushing the Two Pieces Together Firmly.
FIGURE 12
www.hightechpet.com
B: Mount the Mounting Base to Your Wall.
High Tech Pet Products, Inc.