High Tech Pet MS-5 Operating Instructions

High Tech Pet MS-5 Operating Instructions

Electronic pet collar

Advertisement

MS-5
Electronic Pet Collar
For Use With
Power Pet Doors • Sound Barrier • Yard Barrier
OPERATING INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MS-5 and is the answer not in the manual?

Questions and answers

Troy L Klesick
April 13, 2025

1 momth old dog caller tramsmitter shows red light but stops working.. I have changed battery 2 and the red light shows. It has the screw and have tightend it. So the red light shows and the transmitter does not send the a signal. Also when I push the button it will not open..

1 comments:
Mr. Anderson
April 13, 2025

If the High Tech Pet MS-5 collar transmitter shows a red light but does not send a signal or open the door, you should replace the battery. Use the custom battery designed for the MS-5, making sure the lettering faces you and the plus sign is aligned with the transducer. Reassemble the collar by snapping the back on and securing it with the screw.

This answer is automatically generated

Summary of Contents for High Tech Pet MS-5

  • Page 1: Operating Instructions

    MS-5 Electronic Pet Collar For Use With Power Pet Doors • Sound Barrier • Yard Barrier OPERATING INSTRUCTIONS...
  • Page 2 NOTE: the B3V1A Battery (pictured right) is the ONLY battery that is compatible with the MS-5 collar. Do not attempt to use any other battery in the MS-5 collar. NOTE: Some collars are shipped with a battery pre-installed. If the battery is not already pre-installed in the collar, install the battery by following the instructions on next page.
  • Page 3 INSTALLING/ REPLACING THE MS-5 BATTERY 1. Unscrew the bottom cover. 2. Pry bottom off at the location shown here, using a small flat-blade screw- driver or metal nail file. 3. Remove bottom, note battery orientation 4. Remove and replace B3V1A battery 5.
  • Page 4 • Keep the inside of the collar dry. Each time you open it look for water or moisture inside. If detected, remove the battery and use a blow dryer on the circuit board. High Tech Pet Products, Inc. 2476 Palma Drive, Suite A Ventura, CA 93003 www.hightechpet.com...

Table of Contents

Save PDF