Troubleshooting and tips
Troubleshooting and tips
Refer to the safety notes in the "Safety/regulations" manual and in the
started", Page 18
If a fault occurs, try to correct it as described in the following documentation:
•
in this chapter
•
in the documentation for the connected devices
•
in the help systems of the software used
•
in the documentation for your operating system
Help if problems occur
Should you encounter a problem with your computer that you cannot resolve yourself:
► Note the ID number of your device. The ID number can be found on the type
rating plate on the underside of the device.
► For further clarification of the problem, contact the Service Desk for your country (see the
Service Desk list or visit the Internet at "http://support.ts.fujitsu.com/contact/servicedesk"). When
you do this, please have ready the ID number and serial number of your system.
Troubleshooting
Power-on indicator remains unlit after you have
switched on your device
Cause
The mains voltage supply is faulty.
Internal power supply overloaded.
48
chapter when connecting or disconnecting cables.
Troubleshooting
► Check that the power cable is properly
plugged into the device and into the mains
socket.
► Unplug the power plug of the device from
the mains socket.
► Wait approx. 3 min.
► Plug the power plug of the device into the
mains socket again.
► Switch the device on.
"Getting
Fujitsu