Crestron DualTouch DTT-18 Operation Manual page 16

Crestron DTT-18
DVI/RGB Pinouts
Pin 11
Pin 6
VGA (Female)
• DTT-18: DualTouch™ Technology Touchpanel
12
Use the 29-pin to 15-pin adaptor (included) for VGA analog signals. Refer to the
following illustration and table for DVI/I to RGB adapter pinouts.
NOTE: Crestron Part Number for this connector: JDCMDVI-VGAMF-1
Pin 5
Pin 1
DVI/RGB Adaptor Connections
VGA (RGB)
SHIELD
PIN R6, G7, B8
PIN 13
PIN 3
PIN 2
PIN 1
PIN 5,10
PIN 9
PIN 14
PIN 12
PIN 15
NOTE: The USB cable may be extended using up to four 16-foot active extensions.
Each extension cable must contain a hub (repeater) to regenerate the USB signal
(maximum of 64 feet). Crestron has tested and approved IOGEAR USB Extender
model GUCE50, which allows up to 150 feet over CAT5.
NOTE: Using high quality cable, the VGA cable may be extended up to a
maximum of about 10 meters (32.8 ft.) for analog VGA at 1280 x 1024. If you need
a longer run, add VGA extenders or VGA distribution amplifiers.
DualTouch™ Technology Touchpanel
DVI CABLE FUNCTION
SHIELD GROUND
C5 ANALOG GROUND
C4 HORIZONTAL SYNC
C3 ANALOG BLUE
C2 ANALOG GREEN
C1 ANALOG RED
PIN 15 GROUND (+5V & HV SYNC)
PIN 14, 16 POWER +5V/HDT PLUG DETECT
PIN 8 VERTICAL SYNC
PIN 7 DDC DATA
PIN 6 DDC CLOCK
Operations Guide – DOC. 6290
Pin 1
Pin 8
Pin 16
C1
C2
DVI (Male)
Pin 17
Pin 24
C3
C4
C5