Requires - Crestron CNWM-29A User Manual

CRESTRON CNWM-29A Wall-Mount Wired Panel
switch marked H to point to the first (or most-significant) digit or letter of the specified ID CODE. Set the switch marked L to
the second (least-significant) digit or letter of the specified ID CODE.
The 4-pin connector marked NET should be wired to the CRESNET II network. Network termination points are available at
the control system power supply. Network units may also be daisy-chained together. Refer to the latest revision of the
CRESNET II reference manual section on CNPWS power supplies (Doc 8017) for wire gauge specifications and connection
details.
The panel drawing on the previous page shows the location of the SIMPL-C button numbers and their corresponding button
positions. Buttons which are not used need not be assigned a signal name.

REQUIRES:

CRESNET II Workshop Version 4.00 or later.
CRESNET II Operating System SR30160.OPS or later.
R E M O T E C O N T R O L S Y S T E M S
2 DOC. 8000B