Page 3
CAEN enclosure. The table below lists all parts included with the CAEN-MK. Supplied Components NOTE: This mounting kit may also be used for future devices. The front view of a C2N-SPWS300 mounted on a CAEN-MK is shown in the following diagram. C2N-SPWS300 shown with CAEN-MK Attached Installation Guide - DOC.
Page 4
Complete the following assembly procedure in the order provided (refer to illustration below). Assembly View 2 • CAEN Mounting Kit: CAEN-MK 11/32” Wrench or nut driver 8-32 Nuts (quantity four, supplied) 1. Holding the device facing you, position the bracket-mounting studs on metal bracket MTBK02857-1 in the device’s mounting holes as shown...
Page 5
Flat tip screwdriver (optional) 1. Position the assembly to be mounted in front of an available space in a Crestron CAEN enclosure (at the bottom of a single-width enclosure or across two side-by-side spaces in a double-width cabinet) to determine the location of the mounting holes.
CAEN Mounting Kit Further Inquiries If after reviewing this Installation Guide for the CAEN-MK, you cannot locate specific information or have questions, please take advantage of Crestron's award winning customer service team by calling: Future Updates As Crestron adds improvements to the CAEN-MK, additional information may be made available as manual updates.
Purchasers should inquire of the dealer regarding the nature and extent of the dealer's warranty, if any. CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any application other than that for which it was intended, or if it has been subjected to misuse, accidental damage, modification, or improper installation procedures.
Page 8
Crestron Electronics, Inc. Installation Guide – DOC. 6130 15 Volvo Drive Rockleigh, NJ 07647 05.03 Tel: 888.CRESTRON Fax: 201.767.7576 Specifications subject to www.crestron.com change without notice.
Need help?
Do you have a question about the CAEN-MK and is the answer not in the manual?
Questions and answers