Franklin Electric SubDrive Inline 1100 Owner's Manual

BEFORE YOU START
BEFORE INSTALLING PUMP, BE SURE TO READ
THIS OWNER'S MANUAL CAREFULLY.
REFER TO PRODUCT DATA PLATE(S) FOR
ADDITIONAL OPERATING INSTRUCTIONS AND
SPECIFICATIONS.
C A U T I O N
Keep work area clean, well-lit and uncluttered.
Keep safety labels clean and in good condition.
Wear safety glasses while installing or performing
maintenance on pump.
Adhere to the guidelines of the National Electric Code
(NEC) or Canadian Electric Code (CEC), and any other
state and local codes for ALL electrical installations.
Check with the appropriate agencies or contact a
licensed electrician.
Adhere to the guidelines of national, state and local
plumbing codes when installing this product. Check with
the appropriate agencies or water system professional
for additional information. Hazardous voltage.
Can shock, burn, or
Most water system problems result from improper
cause death.
installation. It is suggested that you read this manual
carefully before installing your pump.
Ground pump before
connecting to power
The "TROUBLESHOOTING SECTION" will assist you in
supply. Disconnect
locating and eliminating the cause of any trouble you
power before working
may encounter after installation. Check and make
on pump, motor
available all the tools you will need to install your pump.
or tank.
Required tooling may include wrenches, pipe sealant,
pipe fittings and nipples, screwdriver, etc. Be sure to
have available proper and adequate wiring material to
complete the installation correctly.
INLINE CONSTANT
PRESSURE SYSTEM
OWNER'S MANUAL
IMPORTANT INFORMATION FOR INSTALLERS
THIS EQUIPMENT IS INTENDED FOR INSTALLATION BY
TECHNICALLY QUALIFIED PERSONNEL. FAILURE TO INSTALL
IT IN COMPLIANCE WITH NATIONAL AND LOCAL
ELECTRICAL CODES, AND WITHIN FRANKLIN ELECTRIC
RECOMMENDATIONS, MAY RESULT IN ELECTRICAL SHOCK
OR FIRE HAZARD, UNSATISFACTORY PERFORMANCE, AND
EQUIPMENT FAILURE. FRANKLIN INSTALLATION
INFORMATION IS AVAILABLE FROM PUMP MANUFACTURERS
AND DISTRIBUTORS, AND DIRECTLY FROM FRANKLIN
ELECTRIC. CALL FRANKLIN TOLL FREE 800-348-2420 FOR
INFORMATION.
W A R N I N G
SERIOUS OR FATAL ELECTRICAL SHOCK MAY RESULT FROM
FAILURE TO CONNECT THE INLINE SYSTEM, METAL
PLUMBING, AND ALL OTHER METAL NEAR THE INLINE
SYSTEM OR CABLE, TO THE POWER SUPPLY GROUND
TERMINAL USING WIRE NO SMALLER THAN MOTOR CABLE
WIRES. TO REDUCE RISK OF ELECTRICAL SHOCK,
DISCONNECT POWER BEFORE WORKING ON OR AROUND
THE WATER SYSTEM. DO NOT USE INLINE SYSTEM IN
SWIMMING AREAS.
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury:
D A N G E R
serious personal injury, death or major property damage
if ignored.
W A R N I N G
serious personal injury, death or major property damage
if ignored.
Hazardous voltage.
WA R N I N G
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
C A U T I O N
cause minor personal injury or major property damage
if ignored.
ATTENTION!
OF THIS EQUIPMENT!
warns about hazards that will cause
warns about hazards that can cause
WA R N I N G
warns about hazards that will or can