BQS BNFIX BI 123 Instruction Manual page 18

5. FASTENING THE CHILD. GROUP 2/3
NOTICE
5.1 Removing the harness and the buckle
Before installing the seat for Group 2/3, the seat harness
(C)
protectors
For it:
1. Loosen the harness straps
harness adjustment button
2. Loosen the harness straps from the back of the seat, freeing them from the
harness connector
of the seat (fig. 5.3).
3. Take out the shoulder protectors and store them for future uses.
4. Take off the harness straps and save them in the storage bag.
5. Turn the seat over and, from the back of the seat, take off the safety buckle
(E)
, by passing the retention plate through the seat base slot (fig. 5.4 y 5.5).
6. Take out the safety buckle
5.2 Installing the seat.
1. Place the child safety seat in the back seat of the vehicle facing in the
direction of travel.
2. Place the child in the seat.
3. Pass the diagonal section of the belt through the diagonal belt guide
(B) of the headrest. Pass the abdominal section of the belt over the
guides (J)
guide (J) nearest to the vehicle belt buckle.
4. Pass the vehicle belt and buckle the vehicle seat belt until you hear a click
(fig. 5.7)
IMPORTANT! The part of the abdominal belt should rest as low as possible
over the child's hips, on both sides.
18
GROUP 2/3 only.
From 4 to 12 years (9-18 kg)
(E)
and buckle must be removed.
(D)
(H)
(O) (fig. 5.2). Remove them pulling up from the front side
(E)
(fig. 5.7). Make sure the diagonal belt section pass over the
by pulling them gently while pressing the
(fig. 5.1)
and save it in the storage bag.
(D) , harness
BNFIX BI 123