BQS BNFIX BI 123 Instruction Manual page 16

3. INSTALLING THE SEAT. GROUP 1
1. If your vehicle is not equipped with the ISOFIX insert guides as standard, clip
the two insert guides which are included with the seat with the cut-out facing
upwards onto the two ISOFIX attachment points of your vehicle.
TIP: The ISOFIX attachment points are located between the surface and the
backrest of the vehicle seat.
2. Press the ISOFIX connectors unlocking button
(P) . Move locking arms to check that both are fully unfolded. Pull the fabric
loop (03) to pull out both locking arms to longest position (fig. 3.1).
3. Take the Top Tether and pass it over the seat.
4. Place the child safety seat in the back seat of the vehicle facing in the
direction of travel.
5. Hold the safety seat with both hands and insert the two locking arms
the vehicle´s Isofix connectors until they fasten with a click on both sides.
The red button will change to green on both sides (fig. 3.2).
6. Shake the seat to check that it is correctly anchored to the vehicle's ISOFIX
points.
IMPORTANT! The locking arms are only correctly fixed if both safety buttons
are green.
7. Push the safety seat towards the back using a firm, constant pressure on
both sides until it rests firmly against the vehicle seat (fig. 3.3).
8. Take the Top Tether and press the Top Tether
strap if necessary.
9. Hook the safety clasp
your vehicle instruction manual (fig. 3.4)
IMPORTANT! Make sure not to use the luggage clip instead of
the Top Tether anchor clip. Look for this symbol in your vehicle.
10. To tighten the Top Tether, take up any slack by pulling the free end of
the belt through the Top Tether adjuster (fig. 3.5). The Top Tether will be
correctly tightened when the tension indicator changes from red to green
(fig. 3.6).
16
(L)
to the Top Tether anchor point recommended in
(I) to extract the ISOFIX arms
(K)
adjuster to lenghten the
(P)
into
BNFIX BI 123