Advertisement
Table of Contents
Welding Instruction
Welding fillers to use:
Recommended rod electrode
► BÖHLER FOX 7018 (or similar)
Recommended wire electrode
► BÖHLER EMK 6 TOP (or similar)
General information:
To avoid cracks in the material, a pre-heating of the base material of min. +80 ° C is
recommended.
The welding area at the pewag bluetrack should be dry and clean before welding the
stub.
The welding seam should not be more than 5 mm.
Instruction:
To avoid excessive heating of the base
material please follow the steps below:
If possible, please always work on two
profiles at the same time.
Please weld only ¼ of a pewag
bluetrack stub at the beginning, see
red marking step 1 – 4.
The next step is to weld ¼ of the stub
on the backside, see red marking
step 5 – 8.
Seite 1 von 2
Advertisement
Table of Contents
Related Manuals for pewag bluetrack duo perfekt
Summary of Contents for pewag bluetrack duo perfekt
- Page 1 To avoid cracks in the material, a pre-heating of the base material of min. +80 ° C is recommended. The welding area at the pewag bluetrack should be dry and clean before welding the stub. The welding seam should not be more than 5 mm.
- Page 2 Now start to finish the welding on each side of the stubs, see blue marking. Start first with step 1 – 4 and then continue with step 5 – 8 as shown in the illustration. Leave yourself enough time between the process steps so that the material is allowed to cool down.
Need help?
Do you have a question about the bluetrack duo perfekt and is the answer not in the manual?
Questions and answers