Table of Contents
Advertisement
Table 2. Rear view of the system (continued)
Item
Ports, panels, or slots
6
iDRAC dedicated port
7
USB 2.0 port (1)
8
USB 3.0 port (1)
9
VGA port
10
PCIe expansion card riser
4 (slot 7 and slot 8)
11
Power supply unit (PSU
4)
12
Power supply unit (PSU
3)
13
OCP NIC port (optional)
14
Power supply unit (PSU
2)
15
NIC port (1,2)
16
Power supply unit (PSU 1)
For more information on the ports and connectors, see the www.dell.com/poweredgemanuals.
Icon
Description
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
● If the system stops responding during POST, press and hold
Enables you to remotely access iDRAC. For more information, see
the iDRAC User's Guide at www.dell.com/poweredgemanuals.
This port is USB 2.0-compliant.
This port is USB 3.0-compliant.
Enables you to connect a display device to the system. For more
information, see the www.dell.com/poweredgemanuals.
N/A
The expansion card riser enables you to connect PCI Express
expansion cards. For more information on the expansion
cards that are supported on your system, see
poweredgemanuals.
For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
N/A
This port supports OCP 3.0. The NIC ports are integrated on the
OCP card which is connected to the system board.
For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
The NIC ports are embedded on the LOM card that is connected to
the system board.
For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
button is enabled in the iDRAC setup.
the system ID button (for more than 5 seconds) to enter
the BIOS progress mode.
PowerEdge XE8545 system overview
www.dell.com/
7
Advertisement
Table of Contents
