Cradlepoint MBR95 Product Manual page 82

CRADLEPOINT MBR95 | USER MANUAL Firmware ver. 3.2.4
7.1.3 Failback Configuration (Advanced Mode Only)
This is used to configure failback, which is
the ability to go back to a higher priority
WAN interface if it regains connection to its
network.
Usage: Failback based on the amount of
data passed over time. Use of the active
connection must be below this threshold for
failback to occur. This will limit the
interruption that occurs during failback.
 High (Rate: 80 KB/s. Time Period: 30
seconds.)
 Normal (Rate: 20 KB/s. Time Period:
90 seconds.)
 Low (Rate: 10 KB/s. Time Period: 240 seconds.)
 Custom (Rate range: 1-100 KB/s. Time Period range: 10-300 seconds.)
Time: Failback only after a set period of time. (Default: 90 seconds. Range: 10-300 seconds.) This ensures that the
higher priority interface has remained online for a set period of time before it becomes active (in case the connection is
dropping in and out, for example).
Immediate: Failback immediately whenever a higher priority interface is plugged in or when there is a priority change.
Immediate failback returns you to the use of your preferred internet source more quickly which may have advantages
such as reducing the cost of a failover data plan, but it may cause more interruptions in your network than Usage or Time
modes.
Disabled: Deactivate failback mode.
© 2011 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 80