Nutricia Flocare 800 Manual

Enteral feeding pump

Advertisement

Quick Links

F800 Pump
Pump
Pump
Your healthcare practitioner has advised you to administer your tube feeding using a
Flocare
800 (F800) enteral feeding pump.
®
The F800 is a stationary pump that helps you in administering your feeding regime in
an easy and safe manner.

Daily Care of the F800 pump

> Make sure that your pump, including the sensors and the rotor, is kept clean.
The F800 pump can be cleaned using a damp cotton swab or cloth.
> Always unplug the pump from the electrical circuit prior to cleaning.
> The battery should be maintained at full charge if possible. Keep the pump
connected to the mains whenever possible. If the battery is fully charged, the
pump can operate for 3 hours (at an average speed of 125 ml/h).
The "LOW BATTERY" alarm will sound when approximately 30 minutes of
operation time remain.
The battery will be fully reloaded after ca.12 hours of charging.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Flocare 800 and is the answer not in the manual?

Questions and answers

Summary of Contents for Nutricia Flocare 800

  • Page 1 F800 Pump Pump Pump Your healthcare practitioner has advised you to administer your tube feeding using a Flocare 800 (F800) enteral feeding pump. ® The F800 is a stationary pump that helps you in administering your feeding regime in an easy and safe manner. Daily Care of the F800 pump >...
  • Page 2 Preparation of the F800 pump Have your Flocare feeding set ready for use. ® Open the feeding set and connect it to the feed. ENTERAL FEEDING PUMP ENTERAL FEEDING PUMP ENTERAL FEEDING PUMP ENTERAL FEEDING PUMP RATE ML/HR RATE ML/HR HOLD HOLD RATE ML/HR...
  • Page 3 ENTERAL FEEDING PUMP RATE ML/HR HOLD DOSE COMPLETE OCCLUSION ENTERAL FEEDING PUMP DOSE Stopping or switching off the pump NO FLOW ENTERAL FEEDING PUMP If you need to stop the pump without switching it off, push the key. LOW BATTERY RATE ML/HR HOLD To restart the pump after holding, simply press the...
  • Page 4 Alarm Likely Cause Instructions > There is an obstruction to > Check the feeding set, ensure that OCCLUSION flow, either in the feeding set the roller clamp is fully opened and NO FLOW or in the tube. that there are no kinks in the tubing, and/or >...

This manual is also suitable for:

F800

Table of Contents