Step 12 - Install Accessories - Bryant 548J*14D Installation Instructions Manual

Step 12 — Install Accessories
Available accessories include:
Roof Curb (must be installed before unit)
Thru- - base connection kit (must be installed before unit
is set on curb; see page 15)
Manual outside air damper
Two- - Position motorized outside air damper (see page 9)
EconoMi$er IV (with control and integrated barometric
relief; see page 8)
EconoMi$er2 (without control/for external signal and
integrated barometric relief; see page 8)
Power Exhaust
Differential dry- - bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
Electric Heaters (see page 16)
Single Point kits (see page 17)
Thermostat / Sensors (see pages 21- - 22)
CO sensor (see pages 22- - 24)
2
Louvered hail guard
Phase monitor control
Refer to separate installation instructions for information
on installing these accessories.
Pre- - Start and Start- - Up
This completes the mechanical installation of the unit.
Refer to the unit's Service Manual for detailed Pre- - Start
and Start- - up instructions.
33