Cessna Swapping GIA 1 Manual page 8

Section 2 Software and Configuration Loading
This section will provide the steps necessary to target load the software and configuration into
GIA 1 & GIA 2 after swapping.
Note: Anytime that software or configurations are being loaded, all three displays, and both
touch controllers must be in configuration mode.
Note: Ensure that you have completed the steps contained in Section 1.
• GIA 63W GIA 1 & GIA 2 (Integrated Avionics)
• When GIA 1 & GIA 2 units are swapped, then software and configuration loading is
required.
1) Pull the following circuit breakers:
 L PFD
 MFD
 R PFD
 L Touch Control
 R Touch Control
2) Insert the 010-01121-10 software loader card into the upper slot of PFD 1.
3) Turn on aircraft power.
4) Press and hold the right knob on the left GTC and push the L Touch Control circuit
breaker in.
 Let go when you see initializing.
5) Press and hold the right knob on the right GTC and push the R Touch Control
circuit breaker in.
 Let go when you see initializing.
Version 1.0
8