Cessna Swapping GIA 1 Manual page 21

Section 4 Final Verification / Return to Service
Note: This is with the G3000 powered up in normal mode.
• Select Home on the left GTC controller.
o Select Utilities.
o Select Setup.
o Select Avionics Status.
o Select the Airframe tab on the left side.
o Verify that the configuration ID (CRC Number) matches the number determined in
Appendix A based on the options installed in the aircraft.
o Select the LRU Info tab on the left side.
 Verify that all the LRUs are showing green check mark.
o Select the MSG button:
 Verify there is no DB Mismatch message present.
 Verify there is no Manifest message present.
 Verify there is no Config message present.
• If aircraft is equipped with a GDL 69, or GSR 56:
o Select Home.
o Select Weather.
o Select Weather Selection.
 Verify Connext Weather is present if equipped with a GSR 56.
 Verify Sirius XM Weather is present if equipped with a GDL 69.
• If the initial radar trims were not zero:
o Select Home on the left GTC controller.
o Select Aircraft Systems.
o Select Maintenance.
o Enter password CACCDMS.
o Select Radar Trim.

Return to Service Testing
For testing, complete section 7.17.1 in the Garmin G3000 LMM.
•
Version 1.0
Enter the Pitch and Roll trims recorded in section 1.
21