Get More Information - Shure INTELLIMIX P300 User Manual

Get More Information

Now that the basic setup is complete, you should have access to the web
application and be able to pass audio between devices. More comprehen-
sive information is available online and in the help section, including:
• Maximizing audio quality with the built-in parametric equalizer
• External control system command strings
• Signal routing
• System scenario diagrams
• Software configuration
• Networking information
• Troubleshooting
• Replacement parts and accessories
The complete user guide is available at http://pubs.shure.com/guide/P300
USB Computer System
Computer
input usb
output
Powered Loud-
speaker
1. Connect the computer to the USB port on the P300
2. Connect a powered loudspeaker or amplifier to the P300 analog
output 2. In the matrix mixer, this is labeled Analog - To Speaker.
3. In the P300 web application, open the matrix mixer
to make connections between devices.
Note: Some connections are established in the matrix mixer by default. Refer to
the matrix mixer help topic in the web application for additional information.
Required Matrix Mixer Connections:
Input Output
Automix USB output
USB input Analog - To Speaker
4. In the schematic view, right-click any AEC block and set
the AEC reference channel to Analog - To Speaker.
5. In the web application, adjust input and output levels
and perform a sound check. Refer to the help topics in
the web application for additional information.
reset
Network Switch MXA310
(PoE+ Required)
Hardware Codec System
Video Codec
input
output
Powered Loudspeaker
1. Connect the hardware codec audio output to the P300 analog
input 1. In the matrix mixer, this is labeled Analog - From Codec.
2. Connect the hardware codec audio input to the P300 analog
output 1. In the matrix mixer, this is labeled Analog - To Codec.
3. Connect a powered loudspeaker or amplifier to the P300 analog
output 2. In the matrix mixer, this is labeled Analog - To Speaker.
4. In the P300 web application, open the matrix mixer
to make connections between devices.
Note: Some connections are established in the matrix mixer by default. Refer to
the matrix mixer help topic in the web application for additional information.
Required Matrix Mixer Connections:
Input
Automix
Analog - From Codec
5. In the schematic view, right-click any AEC block and set
the AEC reference channel to Analog - To Speaker.
6. In the web application, adjust input and output levels
and perform a sound check. Refer to the help topics in
the web application for additional information.
5
usb
Network Switch
(PoE+ Required)
Output
Analog - To codec
Analog - To Speaker
reset
MXA910