Sony DSBK-2020 Installation Instructions Manual page 27

Screw
3
Remove the blank panel or connector panel. If there is an i.LINK
(interface) cable connected to the connector panel, remove this.
Note
Keep the blank panel or connector panel and screws carefully, to
avoid loss.
4
Connect the harness to connectors CN201 and CN202 on the TX-
96A board on the HIF-34 board. (Both connectors output the same
signals.)
Board retainer
DSR-2000/2000P/2000A/2000AP
Blank panel (or connector panel)
Board retainer
guide
Screw
Installation 27