Sony DSBK-2020 Installation Instructions Manual page 21

Item number Item name
746 SYNC PHASE (HD)
(HD SYNCPHASE)
747 FINE (HD)
921 ASPECT FLAG
Settings
Make coarse adjustment of the H sync phase
of the HD video signal output from the HD
SDI OUTPUT connector.
0 - 80H - FFH
Note
The H sync phase of the HD SDI output with
respect to the reference video input reflects
the result of adjusting the SD output by
adjusting the sync phase of the DSR-2000/
2000P/2000A/2000AP main unit.
Use this menu item when a further
adjustment of the HD phase with respect to
the SD phase is required.
Make fine adjustment of the H sync phase of
the HD video signal output from the HD SDI
OUTPUT connector.
0 - 20H - 3FH
Note
The H sync phase of the HD SDI output with
respect to the reference video input reflects
the result of adjusting the SD output by
adjusting the sync phase of the DSR-2000/
2000P/2000A/2000AP main unit.
Use this menu item when a further
adjustment of the HD phase with respect to
the SD phase is required.
Specify the treatment of an aspect ratio
identification signal included within the SD
signal.
OFF: The up-converter mode ignores the
aspect ratio identification signal, and
follows menu item 950.
ON: The up-converter mode follows any
aspect ratio identification signal
recorded on the tape or aspect ratio
identification signal attached to the
selected input.
Note
If the aspect ratio identification signal cannot
be detected, the setting of menu item 950
applies.
Overview 21