Assembly - Steel City 35-215S3 Owner's Manual

wArnInG
!
Make sure the switch is in the off position and
the machine is unplugged.
◊ InsTALLInG HeIGHT ADjUsTMenT
HAnDwHeeL
The key, nut and washer are taped onto the handwheel
shaft. Carefully remove the tape to get the parts. Insert
the handwheel, making sure the keyway is aligned with
the key. Install washer and nut and tighten the nut.
Install the handle on the handwheel and tighten.
◊ ATTACHInG THe swITCH Box
To THe FrAMe
Remove the two cap screws installed on the left front
side of the machine. Position the switch assembly and
secure in place using the two cap screws.
Belt Cover
(For Reference)

AsseMBLY

◊ InsTALLInG THe exTensIon
TABLes
wArnInG
!
It can be difficult to install
extension table by one person.
Get assistance when needed.
Install the levelling screws into the extension tables so
they are flush with the surface that faces the machine.
Attach the extension table to the planer using the
mounting bolts. Do not fully tighten the bolts yet. Just
make sure they can hold the table in place.
Align the edge of extension table with the edge of the
planer bed. Make sure the edges are flush with each
other.
Mounting
Use a straight edge approximately four feet long to
Screws
check if tables are parallel with the planer bed. At this
point the tables should be slightly sagged. Make sure
the straight edge is not resting on the bed rollers.
Page 10
Mounting Bolt Set Screw