Table of Contents
Advertisement
10
www.raider.bg
machine is switched off by means of a protective circuit: the tool holder no longer rotates.
Caution: if the On/Off switch is subject to continued use, the Li-ion battery can be damaged.
The charging procedure starts as soon as the mains plug of the battery charger is inserted into
the socket and the adapter plug is connected to the appliance (the underside of the handgrip).
• Put the adapter plug of the charger into the handle (underside)
• Plug the mains adapter into the (wall) socket
• The charging process starts; the red LED is now on
• The battery is fully charged when the red LED goes out.
• Charging the battery takes maximum 5 hours.
• During the charging procedure, the handgrip of the machine warms up. This is normal.
5. Operation and settings. Switching on. Switching off.
5.1. Switching on - press the switch button.
5.2. Switching off - release the switch button.
5.3. Spindle brake.
Screwdriver is equipped with electronic brake, which stops the spindle immediately after the switch is released. The brake ensures
precision when screwing or screwdrivering and prevents free spindle rotation after it is switched off.
5.4. Overload clutch. Torque control.
Setting the ring in given position causes permanent setting of the clutch to specified torque. When the set torque is reached, overload
clutch releases automatically. It prevents screwing screws t deep or damaging the screwdriver.
Different screws and materials require different torque to be applied.
The bigger number corresponding to given position, the bigger the torque.
Set the ring to specified torque.
Always start operation with low torque.
Increase the torque gradually until appropriate value is set.
Use higher settings to unscrew screws.
Knowledge how to choose appropriate settings comes with practice.
Setting the ring in the screwdrivering position deactivates the overload clutch.
5.5. Working tool installation.
Firmly hold the machine and ferm the bit with even pressure into the workpiece. Do not force
the machine. Use only bits that do not yet show any signs of wear. Worn bits have a negative
effect on the efficiency of the machine.
Locking the screwdriver
The screwdriver is fitted with an automatic spindle lock feature. When the On/Off switch is
not pressed, the spindle is locked. Now it is possible to use the screwdriver (even when the
battery is empty) as a manual tool.
Screwdriving
To switch the tool on, press the On/Off switch.
- Press the tumbler switch (R) for clockwise rotation (tightening screws)
- Press the tumbler switch (L) for counterclockwise rotation (loosening screws)
To switch the tool off, release the on/off switch.
User tips for optimum use
• Always hold the tool and screwdriver bit in a straight line with the screw and always use
the correct type and size of bit.
• If screws are difficult to tighten, try applying a small amount of washing liquid or soap as a
lubricant.
• Use the spindle lock feature to loosen very tight screws or to firmly tighten screws.
• When screwing in wood, it is recommended to screwdriver a hole with a depth equal to almost the
length of the screw. A pilot hole guides the screw and prevents splintering or distortion of
the work piece.
5.6. Make periodic breaks at work.
5.7. Keep and refer to the accessories carefully.
5.8. Do not throw the tool, do not overload, do not soak in water and other liquids do not use it for mixing adhesives and concrete
coatings.
Advertisement
Table of Contents
