Leak Check - Coleman 9948-725 Instructions For Use Manual

Install Full Griddle
NOTE: Before using
the Full Griddle,
remove the Cooking
Grate.
Place Full Griddle
on stove making sure
Griddle Pins rest on
stove as shown in
Detail "A."
DETAIL "A"
Using the Propane Cylinder Support
If using the stove on a
tabletop, allow the base of
the propane cylinder to rest
on the surface of the table-
top. Do not use the propane
cylinder support.
If using the stove with its
Legs, pull up and rotate bot-
tle support assembly until
support wire is perpendicular
to stove case.

Leak Check

WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor stove until connection has been leak tested
and does not leak.
NOTE: Use Coleman 16.4 oz disposable propane cylinders. The LP
gas cylinder(s) used with stoves must be constructed and marked in
accordance with the specifications for LP-gas cylinders of the U.S.
Department of Transportation or Transport Canada , CAN/CSA B339.
Step 1
Make sure Burner
Valve is off.
(standard with some models)
Propane
Cylinder
Support
Leak Check
cont.
Step 2
Remove plastic cap from
top of propane cylinder. Save
cap for use in storing. Screw
propane cylinder into REGU-
LATOR. Be careful not to
cross-thread. HAND TIGHTEN
only.
Step 3
Check the connection
between the cylinder and
the regulator with soapy
water. Bubbles indicate a
leak. Check that the con-
nection is not cross-thread-
ed and that it is tight.
Perform another leak check.
If there is still a leak,
remove the cylinder and
contact Coleman for service
or repairs.
The regulator uses a
threaded fitting to attach
to the stove. It is neces-
sary to hold the stove to
make sure the fitting is
seated. Align the regu-
lator to the fuel tube on
the rear of the stove
and push on. Screw on
the outer threaded
sleeve in a clockwise
direction until tight.
Step 4
Never operate stove
with propane cylinder in
an inverted position.
Leak
Check
5