ResMed HumidAire 3i User Manual page 16

W C
ATER HAMBER
D
AILY
Wash the water chamber and tubing in warm water, using a mild detergent
(see previous caution). Use the yellow cleaning plug to assist in the cleaning process
(see steps 1 to 5 below).
1
4
Rinse them thoroughly with clean water and allow them to dry away from direct
sunlight.
W
EEKLY
Inspect the water chamber for wear and deterioration. Replace the water chamber if
any component has cracked, become cloudy or pitted. Replace immediately if there is
any leaking from the water chamber.
If you notice white powder or deposits in the water chamber:
i. Fill the water chamber to the maximum water level mark with a solution of one
part vinegar to ten parts water.
ii. Let the solution soak for ten minutes.
iii. Discard the solution and rinse the water chamber with clean water.
C
OVER AND COVER SEAL
Inspect the cover and cover seal weekly for wear and deterioration. Replace any
damaged parts. When required, wash the cover and cover seal in warm water, using a
mild detergent (see previous caution). Rinse them thoroughly with clean water and
allow them to dry away from direct sunlight.
D S
OCKING TATION
Periodically wipe the outside of the docking station (including the connector seal) with
a damp cloth.
2
5
3
C M
LEANING AND AINTENANCE
11