Heat & Glo COSMO Owner's Manual page 18

Removing Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam, or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
• The glass assembly fastens to the fireplace in four
places. The four fastening mechanisms are spring-
loaded glass latches. An example of the glass latch
is shown in Figure 4.2.
• To release glass assembly, use the supplied multi-
purpose tool. See Figure 4.1. While supporting the
glass assembly, pull the two bottom spring-loaded
latches forward and allow them to retract away from the
glass assembly. Tilt the bottom of the glass assembly
outward until the top latches disengage.
• Clean glass with a non-abrasive commercially available
cleaner.
- Light deposits: Use a soft cloth with soap and water.
- Heavy deposits: Use commercial fireplace glass
cleaner (consult with your dealer).
GLASS CLIPS
Figure 4.1 Mulit-Purpose Tool
Replacing Fixed Glass Assembly
• Verify Glass Seal Plate is properly installed. See Figure
4.3.
WARNING! Glass seal plate must be properly installed.
Risk of elevated component temps and carbon monox-
ide exposure.
• Tilt the top of the glass assembly toward fireplace and
slide glass assembly upward to engage top latches.
Verify top latches are fully engaged and then fasten the
two bottom latches using the supplied multi-purpose tool.
• Reinstall door or decorative barrier front.
Heat & Glo • COSMO-I30-IFT, COSMO-I35-IFT Owner's Manual • 2535-981 Rev. K • 5/21
18
Figure 4.2 Fixed Glass Assembly
GLASS SEAL PLATE
GLASS SEAL
PLATE INSTALLED
Figure 4.3 Glass Seal Plate