Epson Stylus PHOTO RX640 Service Manual page 56

EPSON Stylus PHOTO RX640/650
When installing the CD-R Shaft, orient it so that the side where
the distance from the shaft end to the hole for the hook of the
gear is larger is positioned left (on the spring side), and pass it
through the Stacker. (Fig. 4-38)
Before tightening the screws, confirm the following conditions:
Right and Left Stacker Guides have been installed properly.
(Check the 2 locating holes and 1 projection)
Stacker has been installed properly. (Check the following
positions with the Stacker in the down position.) (Fig. 4-39)
Projections (x2) in the rear (under the Stacker Guides)
Protrusions at right and left sides (inserted in guide groove)
Tighten the screws in the specified order. (Fig. 4-36)
See Fig.4-40 for installation of the CD-R Guide Lever Spring.
C H E C K
If the Stacker is not horizontal in the right and left direction,
P O I N T
remove the right gear, and install the gear again with the Stacker
in the highest position.
Longer side positioned left
Hook hole
Figure 4-38. Installing the CD-R Shaft
Disassembly and Assembly
Install the gear with the shaft in
the highest position
CD-R Shaft
Hook hole
Disassembly of Housing Lower Assy
Insert the projection under the guide
Insert the protrusion
into the guide groove
Figure 4-39. Installing the Stacker
2.Insert the hook end into the guide
1.Put the ring on the shaft
After installing the spring, move Stacker up and down and check the installation of the spring.
~Down~
Figure 4-40. Installing the CD-R Guide Lever Spring
Revision A
Stacker is in the down position
3.Push the ring onto the gear
~Up~
56