Removal Of Exterior Parts; Panel Assy - Epson Stylus PHOTO RX640 Service Manual

EPSON Stylus PHOTO RX640/650

4.2 Removal of Exterior Parts

4.2.1 Panel Assy

1. Open the Scanner Unit, and remove the screws (x3) securing the Middle Cover
Assy. (Fig. 4-1)
Release the hooks (x3 at points marked with ∆) on the Printer Mechanism, the
2.
hooks (x5) in the front and the hook at the right side, and remove the Middle Cover
Assy.
3. Release the hooks at the right and left ends from the direction of the back of the
panel, raise the decorative panel, release all the hooks carefully and remove the
decorative panel. (Fig. 4-2)
4. Remove the screws (x2) securing the Panel Assy. (Fig. 4-3)
5. Lift the Panel Assy, and disconnect the FFCs (x2).
Install the decorative panel, taking care not to confuse the
front and back of the Light Conduction Tubes. (Fig. 4-4)
When installing the Middle Cover, take care not to catch the
Head FFC. If possible, move the carriage to the left
beforehand. (Fig. 4-4)
Hook(x3)
Hook (x5)
Figure 4-1. Removing the Middle Cover Assy
Disassembly and Assembly
C.B.P-TITE 3x10 (x3)
·
Torque : 0.6±0.1N m
Removal of Exterior Parts
Hook (x10)
Figure 4-2. Removing the Decorative Panel
Light Conduction
Tubes
CN15
Figure 4-3. Removing the Panel Unit
Light Conduction Tubes
Middle Cover
Install it in front of
the Head FFC
Figure 4-4. Notes on Installing the Panel Assy
Revision A
C.B.P-TITE 3x8 (x2)
·
Torque : 0.6±0.1N m
Disconnect
Position the thinner
tip upward
Align
43