Eject Frame Assy - Epson Stylus PHOTO RX640 Service Manual

EPSON Stylus PHOTO RX640/650

4.5.7 Eject Frame Assy

1. Remove the Printer Mechanism (p.53)
2. Remove the Ferrite Core Holder (with hooks x2) from the Front Frame, and
remove the Head FFC. (Fig. 4-70)
3. Release the harness of the CD-R sensor from the hook of the Eject Frame.
(Fig. 4-71)
4. Remove the screw securing the Cable Holder Frame.
5. Remove the right and left screws (x2) securing the Front Frame, and remove the
Front Frame from the printer body.
6. Remove the Eject Frame Assy from the printer body. (Fig. 4-72)
Before installing the Eject Frame, install the Left EJ Frame
Spring (longer), and the Right EJ Frame Spring (shorter)
temporarily, in the respective positions shown below on the
Eject Frame. After installing the Front Frame, move the Right
EJ Frame Spring to the spring support.
~Left side~
Left EJ Frame Spring
Fit the shaft holders (left and right) on the underside of the
Eject Frame onto the Paper Eject Roller Shaft. (Fig. 4-72)
After installing the Front Frame, confirm the engagement of
the projections (x2), and then tighten the screws in the
specified order. (Fig. 4-71)
After installing the Cable Holder Frame, confirm the
engagement of the projection, and then tighten the screw.
(Fig. 4 71)
-
After installing the Head FFC as shown, move the carriage
several times and confirm that the FFC is free from undue
tension or excessive allowance. (Fig. 4-70)
Disassembly and Assembly
~Right side~
Right EJ Frame Spring
~Temporarily~
Disassembly and Assembly of Major Parts of Printer
Hooks (x2) at front bottom
Ferrite Core
Holder
Figure 4-70. Removing the Head FFC
Cable Holder Frame
C.B.S-TITE 3x6
·
Torque : 0.8±0.1N
Projection
C.B.S-TITE 3x6 (x2)
Torque : 0.8±0.1N
Projection
1
Release the harness
Figure 4-71. Removing the Front Frame
Shaft holder
Eject Frame Assy
Figure 4-72. Removing the Eject Frame Assy
Revision A
Head FFC
Front Frame
Hook
Locate it on the folded part
m
·
m
2
Front Frame
Shaft holder
Projection
68