Solving Setup Problems; Product Does Not Turn On Or Off; Noise After Filling The Ink - Epson ET-2850 User Manual

2. Select Settings > Restore Default Settings.
3. Select one of these options:
• Network Settings: Resets all network settings.
• Copy Settings: Resets all copy settings.
• Scan Settings: Resets all scan settings.
• Clear All Data and Settings: Resets all control panel settings and any stored information.
You see a confirmation screen.
4. Press the OK button to reset the selected settings. (Press the
operation.)
Parent topic:

Solving Setup Problems

Check these sections if you have problems while setting up your product.

Product Does Not Turn On or Off

Noise After Filling the Ink

Software Installation Problems
Parent topic:
Product Does Not Turn On or Off
If you cannot turn the product on or off, try these solutions:
• If you cannot turn on your product, make sure the power cord is securely connected and hold down
the power button a little longer.
• If you cannot turn off your product, hold down the power button a little longer. If you still cannot turn off
your product, unplug the power cord, plug the power cord back in, then turn your product on and off
again using the power button.
Parent topic:
Noise After Filling the Ink
If you hear noises from your product after filling the ink tanks with ink, check these explanations:
• The first time you fill the tanks with ink, the product must charge its print head. Wait until charging
finishes before you turn off the product, or it may charge improperly and use excess ink the next time
you turn it on. Your product is finished charging the print head when the
Solving Problems
Solving Problems
Solving Setup Problems
stop button if you want to cancel the
197
power light stops flashing.