CERTIFICATION
Bitronics LLC certifies that the calibration of our products is based on measurements
using equipment whose calibration is traceable to the United States National Institute
of Standards Technology (NIST).
INSTALLATION AND MAINTENANCE
Bitronics LLC products are designed for ease of installation and maintenance. As with
any product of this nature, installation and maintenance can present electrical hazards
and should be performed only by properly trained and qualified personnel. If the
equipment is used in a manner not specified by Bitronics LLC, the protection provided
by the equipment may be impaired.
In order to maintain UL recognition, the following Conditions of Acceptability shall
apply:
a) After installation, all hazardous live parts shall be protected from contact by
personnel or enclosed in a suitable enclosure.
WARRANTY AND ASSISTANCE
This product is warranted against defects in materials and workmanship for a period of
thirty-six (36) months from the date of their original shipment from the factory.
Products repaired at the factory are likewise warranted for eighteen (18) months from
the date the repaired product is shipped, or for the remainder of the product's original
warranty, whichever is greater. Obligation under this warranty is limited to repairing or
replacing, at our designated facility, any part or parts that our examination shows to be
defective. Warranties only apply to products subject to normal use and service. There
are no warranties, obligations, liabilities for consequential damages, or other liabilities
on the part of Bitronics LLC except this warranty covering the repair of defective
materials. The warranties of merchantability and fitness for a particular purpose are
expressly excluded.
For assistance, contact Bitronics LLC at:
Telephone:
610.997.5100
Fax:
610.997.5450
Email:
bitronics@novatechweb.com
Website:
www.novatechweb.com/bitronics
Shipping:
261 Brodhead Road
Bethlehem, PA 18017-8698
USA
ML0038
September 27, 2017
- 6 -
Copyright 2017 Bitronics, LLC
Need help?
Do you have a question about the M350 and is the answer not in the manual?