Table of Contents
Advertisement
Owner's Instruction and Operation Manual
Model Number:
SP1000
Report Number: F21-690
Certified to ASTM E1509-12 (2017),
and ULC-S627-00-REV1
Mobile home approved.
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result.
For your safety, follow the installation instructions. Never use make-shift compromises
during the installation of this heater. Contact local building or fire officials about permits,
restrictions and installation requirements in your area. NEVER OPERATE THIS PRODUCT
WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room heater.
Failure to follow instructions may result in property damage, bodily injury, or even death.
Improper Installation Could Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
© 2021 Breckwell, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
Save These Instructions In A Safe Place For Future Reference.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to www.P65warnings.ca.gov
852185K-0805K
Ph. 800-750-2723
Advertisement
Table of Contents
Related Manuals for Breckwell SP1000
Summary of Contents for Breckwell SP1000
- Page 1 State of California to cause emissions standards. cancer, birth defects, and/or other reproductive harm. For more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2021 Breckwell, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 INTRODUCTION This manual describes the installation and operation of the Breckwell, SP1000 wood heater. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood heaters sold after May 15, 2020. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 5,813 to 31,935 Btu/hr, 1.5 g/ hr, and 66% efficiency.
-
Page 3: Installation Checklist
Your wood stove should be installed by a qualified installer only. An NFI qualified Installer can be found at www.nficertified. org/public/find-an-nfi-pro/ For customer service, please contact your Breckwell dealer. COMMISSIONING CHECKLIST This checklist is to be completed in full by the qualified person who installs this unit. Keep this page for future reference. -
Page 4: Installation
• INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER. • DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST Breckwell highly recommends your stove be installed by a VENTING SYSTEM OF THIS UNIT. qualified NFI (US) or WETT (Canada) technician. To find the •... -
Page 5: Combustion Air Supply
Sources of Outside Combustion Air 4” (diameter in size. The stove was tested with Simpson a. In fireplaces Duravent brand. CLass “A” chimney is not required. Refer • Chimney top. to the instructions provided by the vent manufacturer, © 2021 Breckwell... -
Page 6: Vertically With New Chimney System
8. Locate terminations: storm collar down until it sits on the flashing. Seal and a. Not less than 3 feet above any forced air inlet located install cap. Mobile home installations must use a spark within 10 feet; arrester. © 2021 Breckwell... -
Page 7: Vertically Into Existing Chimney System
If outside combustion air is to be used, of the tee is level with the center of the hole in the you will need a pipe length equal to the chimney height masonry as shown. plus 18” (458 mm). © 2021 Breckwell... -
Page 8: Special Mobile Home Requirements
120V, 60Hz electrical outlet. DO NOT connect the unit to a GFCI socket. Voltage variations can lead to serious performance problems. The Breckwell electrical system is designed for 120V AC with no more than 5% variation. Breckwell cannot accept © 2021 Breckwell... -
Page 9: Operation
NOTE: When dropping 3 or more heat level settings (4 to • While the stove’s auger system is feeding pellets, the 1, or 5 to 2 or 1), push the “High Fan” button and allow the green light (in the “Fuel Feed” box) will be on. © 2021 Breckwell... -
Page 10: Manual Mode
MODES TO SWITCH BETWEEN ANY OF THE THREE MODES, THE This heater is designed to burn only PFI Premium grade STOVE MUST BE SHUT OFF, THE NEW MODE SELECTED pellets. DO NOT BURN: AND THE STOVE RESTARTED. © 2021 Breckwell... -
Page 11: Proper Fuel
• The damper may need to be closed during startup. prevents proper pellet feed. Burning wood in forms other • DO NOT add pellets to the burn pot by hand. © 2021 Breckwell... -
Page 12: Opening Door
“On/Off” button to re-start WHEN REFILLING. your stove. The stove will have to fully shut down and turn • DO NOT OVERFILL HOPPER. off before you will be able to restart the stove. © 2021 Breckwell... -
Page 13: Shutdown Procedure
• Heat Exchange Tubes - This stove is designed with a built- in heat exchange tube cleaner. This should be used every © 2021 Breckwell... -
Page 14: Maintenance
THE GROUND, WELL AWAY FROM ALL COMBUSTIBLE on the flue lining. When ignited, this creosote makes an MATERIALS, PENDING FINAL DISPOSAL. extremely hot fire, which may damage the chimney or even destroy the house. Despite their high efficiency, pellet stoves © 2021 Breckwell... -
Page 15: Spring Shutdown
Check the hopper periodically to determine if there is any and pellets stop flowing (this can be done by pressing the sawdust (fines) that is building up in the feed system or © 2021 Breckwell... -
Page 16: Maintenance Schedule
Gaskets Inspected Glass Wiped Cleaned Use the following as a guide under average use conditions. Empty & Gaskets around door and door glass should be inspected Hopper (end of season) Vacuumed and repaired or replaced when necessary. © 2021 Breckwell... -
Page 17: Troubleshooting Guide
(you may want to remove the hose entirely off the stove and the air switch first and make sure it is clear). If you hear a click, the air switch is working. BE CAREFUL! TOO MUCH VACUUM CAN DAMAGE THE AIR SWITCH. © 2021 Breckwell... - Page 18 Remove the control board. On the back, there is one fuse. If it appears to be bad, blown. replace it with a 5 Amp 125 Volt fuse. Plug the stove back in and try to run the unit. © 2021 Breckwell...
- Page 19 Remove the auger motor from the auger shaft and try to run the unit. If the motor will Bad auger motor. turn, the shaft is jammed on something. If the motor will not turn, the motor is bad. © 2021 Breckwell...
- Page 20 “GLASS ‘SOOTS’ UP AT A VERY trim setting for the low feed rate. If the stove is being burned on one of the two lower FAST RATE” only. settings, advance to the next trim setting and try burning the stove. © 2021 Breckwell...
- Page 21 All joints should be properly sealed. Also, clean your stove following instructions in the “Maintenance” section of this manual. If problem persists, contact your dealer. © 2021 Breckwell...
-
Page 22: Electrical Diagram
Other information that may be needed would be the part number and part description of the item(s) in question. Part numbers and descriptions can be found in the “Repair Parts” section of this manual. Once this information has been gathered you can contact your Breckwell dealer or visit www.Breckwell.com Model Information Model Number Dealer’s Name... -
Page 23: Replacement Parts
REPLACEMENT PARTS © 2021 Breckwell... - Page 24 Hinge Pin (.370 Dia X 1.00) 40571 Hinge Block IN ORDER TO MAINTAIN WARRANTY, COMPONENTS MUST BE REPLACED USING BRECKWELL PARTS PURCHASED THROUGH YOUR DEALER OR DIRECTLY FROM BRECKWELL. USE OF THIRD PARTY COMPONENTS WILL VOID THE WARRANTY. © 2021 Breckwell...
- Page 25 ITEMS DEFINED © 2021 Breckwell...
-
Page 26: Service Record
Date: _____________________ Engineer Name: _________________________________ Engineer Name: _________________________________ License No.: _____________________________________ License No.: _____________________________________ Company: ______________________________________ Company: ______________________________________ Telephone No.: __________________________________ Telephone No.: __________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: __________________________________ Items Replaced: __________________________________ © 2021 Breckwell...
Need help?
Do you have a question about the SP1000 and is the answer not in the manual?
Questions and answers