Table of Contents
Advertisement
Contacts for
connecting an
external power
source
7. When the power is connected at the first time the device automatically switches to
the "Active" mode and starts registration in the network. But if the device with
connected battery or an external power has been switched to the "Storage" mode
(by the pressing on the start button more than 5 sec) then you need to press the
button to start.
Start button on the
board
8. By the laptop make sure that the device successfully sends the data.
9. Assembling the device.
10. DIN-rail mounting or another available way to mount the device on the object.
Before connecting the device to the network, make sure that its registration
data is entered in the network - Device EUI, Application EUI and Application
Key for OTAA, or Device address, Application session key and Network
session key for ABP
16
M-BUS-1 / User Manual
Connector for
battery
Revision 15 – 30 June 2021
Advertisement
Table of Contents
